NCERT Class 10 Science projects for students
Electricity, magnetism, light, electrolysis and renewable energy — the Class 10 practicals, each mapped to its chapter.
Class 10 is the practical year, because the board examination wants a model and an investigation rather than a diagram. The projects here are the ones that suit that: Ohm’s triangle proves a relationship, the hand-crank generator makes Faraday’s law visible, and the electrolysis setup splits water with a current the class supplied themselves.
Every project on this page names its chapter — Electricity, Magnetic Effects, Light, Chemical Effects, Sources of Energy — so it can be placed in the term plan and marked against the syllabus. The materials are listed and the method is given as steps, because a project that cannot be reproduced by another group is not evidence of anything.
What you need
The parts below are the ones the most of these projects share. Each project page lists the full set for that build.
| Part | Used by | Why |
|---|---|---|
| 1× 9V battery | 3 | The supply the circuit runs on |
| 1× switch | 2 | Makes and breaks the circuit |
| Breadboard | 2 | Holds the circuit together without solder |
All 8 ncert class 10 science projects
Easiest first. Each card links to the project's own page with the wiring, the parts and the code written out.
Mix any color with three separate LED channels
NCERT Class 10 Ch 12 — V = I × R
NCERT Class 10 Ch 13 — right-hand rule in your hand
NCERT Class 10 Ch 14 — energy from the sun
NCERT Class 10 Ch 13 — moving a magnet makes electricity
NCERT Class 10 Ch 11 — how the eye focuses light
NCERT Class 10 Ch 14 — kinetic energy to electricity
NCERT Class 10 Ch 3 — electrolysis of water
How to use these with a class
These 8 projects run from about 20 minutes to 30 minutes each, and 1 of them are Tier 1 — one component and one idea, which is what a class can finish in a single period.
8 of the 8 projects on this page carry the NCERT Science chapter they map to, so the practical and the syllabus can be taught together rather than side by side.
Every one of them can be practised in the browser simulator first, with the real sketch and a real circuit solver behind it, and the first 15 projects are free with no account.
Common questions
Which is the best project for a board exhibition?
The hand-crank generator. It is visible, it is self-powered, it produces a real LED from nothing but a magnet and a coil, and it can be demonstrated over and over without wearing out.
How much does the electrolysis setup cost?
A battery, two pencil leads, a glass of water with a spoon of baking soda and two small tubes. The setup costs almost nothing, and the hydrogen bubbles are unmistakable.
Can a class do two of these in a term?
Yes — these are one-period practicals once the materials are gathered. Put the solar heater and the wind turbine early in the term, because both need sun and wind to produce a result.
Related
Try the full simulator with your class
103 guided circuit projects, 21 lessons and an in-browser Arduino simulator. The first 15 projects are free, no account needed. One licence covers a whole school.