T ThinkEdge Learn

RGB Color Mixer — Three Switches, Seven Colors

Mix any color with three separate LED channels

RGB Color Mixing Switches
RGB LED project for beginners · Tier 1 · Basics · Easy · 25 min

What you will learn

What you will need

Component
1× 9V battery
3× slide switches
3× 220Ω resistors
1× red LED
1× green LED
1× blue LED
Breadboard
8× jumper wires

Step by step

  1. Step 1

    Place the battery on the left, three switches in a vertical column, three resistors, then the three LEDs on the right (red on top, green in the middle, blue on the bottom).

  2. Step 2

    For each color: connect battery + → switch → resistor → LED anode (long leg).

  3. Step 3

    Connect all three LED cathodes (short legs) back to the battery − (they can share one wire to the − rail).

  4. Step 4

    Flip combinations of switches to mix colors: just red = red, red + green = yellow, all three = white.

Curriculum

This project maps to NCERT Class 10 Science — Ch 11 · The Human Eye and Colourful World. Teachers following the NCERT syllabus can use it as the practical for that chapter.

Take it further

Practise it before you build it

Wire this circuit in the ThinkEdge Learn simulator first. The simulator runs a real Arduino sketch against a modified-nodal-analysis solver, so the LED on screen actually lights when the current is right — no hardware, no burnt components, and a class can try it in a browser.

Open the interactive lab See plans for your class

Related projects

LED Light UpYour first circuit — light it up Button-Controlled LEDPress to light, release to turn off Arduino — Blink Without DelayUse millis() instead of delay() — the right way to blink Arduino — Fade an LED with PWManalogWrite on D9 — the smoothest way to dim an LED Arduino — Button + Buzzer DoorbellPress the button, hear a tone. The classic Arduino starter. Arduino Nano — Temperature on Serial MonitorRead the room temperature every 2 seconds and print it

Guides that use this project

2 guides on the site build this project as part of a longer explanation. The guide says why the circuit works; this page says how to wire it.

Smart Lighting: The Driver, the Controller and the RadioSmart lighting is a driver, a controller and a radio. Learn PWM, current limits, MOSFET switching and flicker, then build a lamp you can query. Tinkercad CircuitsTinkercad Circuits is a free browser simulator for Arduino. What it teaches well, where it stops, and why it is a good first step before a real board.

Where this project sits

It is also part of these lists, which is how a class usually finds it.

NCERT Class 10 Science projects for students8 projects in this list

Try the full simulator with your class

103 guided circuit projects, 21 lessons and an in-browser Arduino simulator. The first 15 projects are free, no account needed. One licence covers a whole school.