T ThinkEdge Learn

LED Light Up

Your first circuit — light it up

Led Blink
LED blink project for beginners · Tier 1 · Basics · Beginner · 20 min

What you will learn

What you will need

Component
1× 9V battery
1× slide switch
1× 220Ω resistor
1× red LED
Breadboard
4× jumper wires

Step by step

  1. Step 1

    Place the battery on the left, switch in the middle-left, resistor in the middle-right, and LED on the right.

  2. Step 2

    Connect battery + to one side of the switch.

  3. Step 3

    Connect the other side of the switch to one end of the resistor.

  4. Step 4

    Connect the other end of the resistor to the LED's long leg (anode, +).

  5. Step 5

    Connect the LED's short leg (cathode, −) back to the battery −.

  6. Step 6

    Flip the switch on — the LED lights up. Flip off — it goes dark.

Curriculum

This project maps to NCERT Class 6 Science — Ch 9 · Electricity and Circuits. Teachers following the NCERT syllabus can use it as the practical for that chapter.

Take it further

Practise it before you build it

Wire this circuit in the ThinkEdge Learn simulator first. The simulator runs a real Arduino sketch against a modified-nodal-analysis solver, so the LED on screen actually lights when the current is right — no hardware, no burnt components, and a class can try it in a browser.

Open the interactive lab See plans for your class

Related projects

Button-Controlled LEDPress to light, release to turn off RGB Color Mixer — Three Switches, Seven ColorsMix any color with three separate LED channels Arduino — Blink Without DelayUse millis() instead of delay() — the right way to blink Arduino — Fade an LED with PWManalogWrite on D9 — the smoothest way to dim an LED Arduino — Button + Buzzer DoorbellPress the button, hear a tone. The classic Arduino starter. Arduino Nano — Temperature on Serial MonitorRead the room temperature every 2 seconds and print it

Guides that use this project

8 guides on the site build this project as part of a longer explanation. The guide says why the circuit works; this page says how to wire it.

How to Learn RoboticsHow to learn robotics without a degree: the order to learn electronics, code and control in, how long each stage takes, and the projects that prove each one landed. Robotics for BeginnersRobotics for beginners: five projects that take you from a blinking LED to a robot that steers itself, with the parts and the mistakes at each step. Arduino Projects for BeginnersTen Arduino projects for beginners that really work, in the order that makes them easiest, with the parts each one needs and the mistake that catches people out. How to Learn ArduinoHow to learn Arduino properly: an eight-week plan from a blinking LED to real builds, with the parts to buy first and the mistake that slows most beginners down. Arduino Cloud EditorWhat the Arduino Cloud Editor is, what it does that the desktop IDE does not, and the honest limits you hit when a class runs entirely in a browser. Tinkercad CircuitsTinkercad Circuits is a free browser simulator for Arduino. What it teaches well, where it stops, and why it is a good first step before a real board. Arduino IDE Download and SetupWhere to download the Arduino IDE safely, which version to pick, the board manager and library manager steps, and the three install problems almost everyone hits. arduino.cc and the Official Arduino Resourcesarduino.cc is the official Arduino site: the language reference, the board specs, the library registry and the free learning resources worth using in class.

Where this project sits

It is also part of these lists, which is how a class usually finds it.

NCERT Class 6 Science projects for students4 projects in this list

Try the full simulator with your class

103 guided circuit projects, 21 lessons and an in-browser Arduino simulator. The first 15 projects are free, no account needed. One licence covers a whole school.