Button-Controlled LED
Press to light, release to turn off
What you will learn
- The difference between a momentary switch (pushbutton) and a maintained switch (slide switch)
- How switches are placed in series to control the entire circuit
- How a series circuit works — current flows through every component in the loop
What you will need
| Component |
|---|
| 1× 9V battery |
| 1× pushbutton |
| 1× 220Ω resistor |
| 1× green LED |
| Breadboard |
| 4× jumper wires |
Step by step
-
Step 1
Place the battery, pushbutton, resistor, and LED in a row on the breadboard.
-
Step 2
Connect battery + to one side of the pushbutton.
-
Step 3
Connect the other side of the pushbutton to one end of the resistor.
-
Step 4
Connect the other end of the resistor to the LED's long leg (anode, +).
-
Step 5
Connect the LED's short leg (cathode, −) back to the battery −.
-
Step 6
Hold the button down — the LED lights up. Release — it turns off.
Curriculum
This project maps to NCERT Class 6 Science — Ch 9 · Electricity and Circuits. Teachers following the NCERT syllabus can use it as the practical for that chapter.
Take it further
- Swap the pushbutton for a slide switch — what changes about the behavior?
- Add a second LED in parallel with the first one — both light up when you press.
- Build a "hold to light" version vs a "tap to toggle" version — how would you change the wiring?
Practise it before you build it
Wire this circuit in the ThinkEdge Learn simulator first. The simulator runs a real Arduino sketch against a modified-nodal-analysis solver, so the LED on screen actually lights when the current is right — no hardware, no burnt components, and a class can try it in a browser.
Related projects
Guides that use this project
8 guides on the site build this project as part of a longer explanation. The guide says why the circuit works; this page says how to wire it.
Where this project sits
It is also part of these lists, which is how a class usually finds it.
Try the full simulator with your class
103 guided circuit projects, 21 lessons and an in-browser Arduino simulator. The first 15 projects are free, no account needed. One licence covers a whole school.