Arduino servo motor projects for students
Servos sweep, point, follow light and grip — the projects where a PWM signal turns into actual movement.
A servo is where electronics becomes movement, and it is the point at which a lot of classes stop being able to finish a project: the servo needs its own supply, the pulse has to be right, and the mechanism has to be mounted so it can actually move. Each of the projects here removes one of those three difficulties at a time.
The sweep is the first one, and it works on the first try every time. After that the angle comes from a button, then from a knob, then from a light sensor, and finally four servos move at once on a Mega. The jump from one servo to four is mostly a power problem, and the page for that project explains it.
What you need
The parts below are the ones the most of these projects share. Each project page lists the full set for that build.
| Part | Used by | Why |
|---|---|---|
| Breadboard | 8 | Holds the circuit together without solder |
| 1× servo motor (SG90) | 8 | The movement |
| 1× 9V battery | 4 | The supply the circuit runs on |
| 1× breadboard | 4 | Holds the circuit together without solder |
| 1× Arduino | 3 | The board that runs the sketch |
| 1× slide switch | 3 | Makes and breaks the circuit |
All 12 arduino servo motor projects
Easiest first. Each card links to the project's own page with the wiring, the parts and the code written out.
Sweep back and forth forever
Press A → go to 0°. Press B → go to 180°.
A continuous rotation — the engineering of big wheels
Make a servo motor wave back and forth
Twist to point
A light sensor that tells the time of day
It always faces the brightest spot
Drive 4 servos at once for a pan-tilt-gripper-tilt arm
A servo that follows the light, like a real solar panel
A servo sweeps the ultrasonic sensor to scan the room
When the pet is near, drop food
A cardboard hand controlled by fishing line — anatomy meets engineering
How to use these with a class
These 12 projects run from about 25 minutes to 90 minutes each, and 0 of them are Tier 1 — one component and one idea, which is what a class can finish in a single period.
Each project page carries the full build — the concept, the parts, the wiring one step at a time and the sketch — so a class can work through it without the teacher having to explain every wire.
Every one of them can be practised in the browser simulator first, with the real sketch and a real circuit solver behind it, and the first 15 projects are free with no account.
Common questions
Do servos need a separate power supply?
For one small SG90 on the USB supply, usually not. For four of them, yes — the USB port cannot deliver the current, and the brown-out that follows looks like a fault in the code. The four-servo robot arm project specifies an external 5 V pack and says why.
How does the Arduino tell the servo where to point?
With pulses on a PWM pin. The width of each pulse is the position — roughly 1 ms for one end of the travel and 2 ms for the other, about 50 times a second. The Servo library measures the pulse and does the rest.
Is a servo project suitable for class 9?
Yes, with the sweep or the knob first. The self-balancing and the robot arm need a mount and a steady hand, so they work better with older students or with a teacher doing the first build alongside.
Related
Try the full simulator with your class
103 guided circuit projects, 21 lessons and an in-browser Arduino simulator. The first 15 projects are free, no account needed. One licence covers a whole school.