Air Taxis and eVTOL Aircraft
An air taxi is a small aircraft that carries passengers on demand, usually on short fixed routes. Most designs are electric, and most of the difficulty is not in the aircraft.
The core engineering problem
A helicopter is good at hovering and bad at cruising. It has to keep its rotors spinning fast to generate lift, and all that power goes into moving air downwards rather than forward, so fuel use climbs steeply with speed. A fixed-wing aircraft is the opposite: cheap to fly fast, hopeless at hovering.
An eVTOL tries to be both. Several designs use separate rotors for vertical lift and a wing for cruise, which is simple and means two separate certified systems. Others use tilting rotors or tilting wings, which is lighter and more elegant and much harder to certify, because a failure in the tilt mechanism now affects the aeroplane as well as the hover.
Why certification is the wall
The aircraft is the easy part. A new air taxi has to be certified to the same standard as every other airliner, which means demonstrating that thousands of things cannot go wrong at once. That is tens of thousands of hours of testing and analysis, and it is why the first generation of these aircraft are being certified in small numbers rather than in volume.
It also means the operating environment has to be designed around the aircraft: vertiports, routes cleared in advance, and airspace rules for a new class of vehicle that flies low over cities.
Step by step
-
Understand the trade-off
Hovering is expensive, cruising on a wing is cheap. Every eVTOL layout is an answer to that single trade-off.
-
Learn the main configurations
Separate lift plus wing, tilting rotors, tilting wings and vectored thrust. Each trades weight against complexity.
-
Understand distributed electric propulsion
Many small motors fail more gracefully than one large one, and electric motors are simpler to certify than combustion.
-
Understand energy density
A battery has roughly a tenth the energy per kilogram of aviation fuel. That number sets the range and it is not going away soon.
-
Understand what certification demands
Systems safety, reliability targets and a demonstration programme measured in years, not quarters.
-
Look at the infrastructure requirement
Vertiports, charging, and airspace corridors are the part that determines whether a service works in a city.
What you'll need
| Item | Qty | Why |
|---|---|---|
| Brushless motor and ESC set | 8 | The distributed propulsion arrangement that defines the architecture. |
| Flight controller with redundant IMU | 2 | Redundant attitude sensing, because a single failure cannot be tolerated. |
| High-voltage battery pack | 2 | Energy density is the limiting factor on every eVTOL design. |
| Airspeed sensor and pitot tube | 1 | Airspeed is the primary flight instrument during the wing-borne phase. |
| Pitot-static instrument | 1 | Airspeed and altitude, the two numbers a wing needs to fly on. |
| Telemetry and command link | 2 sets | Redundant links, with a defined behaviour when both are lost. |
Practise it before you build it
Every step above has a matching circuit in the ThinkEdge Learn simulator. The simulator runs a real
Arduino sketch against a modified-nodal-analysis solver, so digitalWrite actually drives the
LED on screen and the readings change when you change the wiring — no hardware, no burnt components.
The Mega has 4 hardware serial ports (Serial, Serial1, Serial2, Serial3). That means you can talk to 4 different devices at the SAME time — like a GPS, a Bluetooth module, an XBee radio, and the USB. Use 3 of those ports to read 3 different sensors in parallel and stream their data to the Serial Monitor as a CSV row every second. This is the foundation of every real Arduino data logger.
Mount an HC-SR04 ultrasonic sensor on top of a servo. Sweep the servo from 0° to 180° and back, and at each step measure the distance. Print the results to the Serial Monitor as "angle,distance" pairs. Open the Serial Plotter in the Arduino IDE to see a live radar-like graph of the room. With Processing on your computer, you can build a full visual radar.
A real traffic light runs a state machine: GREEN (cars go) → YELLOW (slow down) → RED (cars stop) → PEDESTRIAN WALK (cross the road) → RED → GREEN. The Mega has enough pins to build a full intersection: 3 LEDs for cars in one direction, 3 LEDs for cars in the other, 2 LEDs for the pedestrian signal, and a button to request to cross. Use millis() for non-blocking timing so the button check is responsive.
A real robot arm has at least 4 servos: base rotation, shoulder, elbow, and gripper. The Mega can drive all 4 from independent PWM pins (D9, D10, D11, D12) using the Servo.h library. Each servo is told an angle (0-180°) and the library generates the right PWM signal automatically. The four potentiometers (A0–A3) act as the RC controller — twist them and each servo follows in real time, just like a real robot arm teaching pendant.
The Ferris wheel (originally built for the 1893 World's Fair by George Washington Gale Ferris Jr.) is a giant rotating wheel with passenger cars attached to the rim. As the wheel turns, each car stays upright thanks to gravity — the axle of the car pivots as it rotates. In this mini version, you'll use a small servo motor to slowly rotate a cardboard wheel. The same principle of "slow continuous rotation driven by a small motor" is used in wind turbines, radar antennas, satellite dishes, and rotating signs.
A real solar panel tracks the sun across the sky to capture 30-40% more energy than a fixed panel. We can build a simple 1-axis version with two LDRs (one on each side of a divider) and a servo. The Arduino reads both LDRs, compares them, and turns the servo toward the brighter side. With more LDRs, you can do 2-axis tracking.
Common questions
When will air taxis be a normal part of travel?
Short routes between airports and city centres are the most likely first use, and several certification programmes are already underway. Mass adoption depends on building vertiport infrastructure, which is slower than building the aircraft, so the realistic timeline is measured in years rather than months.
How much quieter are electric air taxis than helicopters?
Considerably, because the main noise source in a helicopter is the rotor blade passing the tip at high speed. Electric distributed rotors turn more slowly for the same thrust and spread that noise across many smaller units, so the sound is more of a hum and less of a thump. It is still clearly audible, which matters for the routes that are approved.
Why do eVTOL designs use so many motors?
Redundancy and distributed lift. Many smaller motors mean that losing one degrades performance rather than ending the flight, and each can be smaller and lighter than one large rotor would be. The cost is a large number of power electronics, which is where much of the weight and much of the certification work sits.
Related guides
Try the full simulator with your class
103 guided circuit projects, 21 lessons and an in-browser Arduino simulator. The first 15 projects are free, no account needed. NCERT Science mapping on 47 projects, with Arabic and English copy in the regional builds.